HP XP P9500 Storage - Manual (Page 142)

¢
When a correct license key is entered, the installation program
displays a message that indicates the license was installed.
¢
Take care that if you enter an incorrect license key three times,
installation stops.
6
.
Execute the following command to check that the package is installed, by
the version number in the output results:
The following shows an example of executing the command:
For Solaris 8, Solaris 9, or Solaris 10
# pkginfo -l DLManager
PKGINST: DLManager
NAME: Dynamic Link Manager
CATEGORY: system
ARCH: sparc
VERSION: xx.x.x.xxxx
BASEDIR: /
VENDOR:
...
#
For Solaris 11
# pkg info DLManager
Name: DLManager
Summary: Dynamic Link Manager
State: Installed
Publisher: Hitachi
Version: x.x.x.x
Build Release: 5.11
...
#
7
.
Restart the host.
When Sun Cluster is not being used:
Execute one of the following commands:
¢
# reboot
¢
boot (at the ok prompt)
When Sun Cluster is being used:
Execute the following command at one of the nodes:
# /usr/cluster/bin/scshutdown -g0 -y
Then, execute the following command at the ok prompt in all nodes:
boot
Note
You must restart the host immediately after a successful upgrade
installation or re-installation has been confirmed.
8
.
Execute the dlnkmgr command's view operation to display the status of
the programs.
The following shows an example of executing the command:
3-76
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide for Solaris ®