HP XP P9500 Storage - Manual (Page 303)

¢ boot -r (at the ok prompt)
20
.
Execute the dlnkmgr command's view operation specifying the -lu
parameter, and check that the configuration has changed.
21
.
If you are using Sun Cluster, remove the device ID information of devices
that do not exist. Execute the following command:
# /usr/cluster/bin/scdidadm -C
22
.
If you are using Sun Cluster, assign device IDs. Execute the following
command:
# /usr/cluster/bin/scdidadm -r
23
.
If you are using Sun Cluster, notify the server of the new device ID
information. Execute the following command:
# /usr/cluster/bin/scdidadm -ui
24
.
If you are using Sun Cluster, update the Sun Cluster global device
namespace. Execute the following command:
# /usr/cluster/bin/scgdevs
25
.
If you cleared the settings for a Quorum device in step 3, perform the
following procedure:
When using, as a Quorum device, an HDLM device of an LU newly
recognized for the first time by HDLM driver, set up the Quorum device on
any node in the cluster. The following shows an example of executing the
command:
Check the device ID of the HDLM device.
# /opt/DynamicLinkManager/bin/dlnkmgr view -path
# /usr/cluster/bin/scdidadm -L
Set up the Quorum device:
# /usr/cluster/bin/scconf -a -q globaldev=d4
For cluster configurations with two nodes, execute the following command
to clear the install mode for the cluster:
# /usr/cluster/bin/scconf -c -q reset
26
.
If you cleared the settings for a disk device group in step 5, perform
registration for the disk device group.
If you are using VxVM, see
Linking VxVM and Sun Cluster on page 3-168 .
If you are using SDS, see To Use a Shared Diskset on page 3-172 of
Registering HDLM Devices on page 3-171 .
If you are using SVM, see To Use a Shared Diskset on page 3-175 of
Registering HDLM Devices on page 3-175 .
27
.
Recreate any metadevices you deleted in step 8.
HDLM Operation
4-41
Hitachi Dynamic Link Manager User Guide for Solaris ®