HP XP P9500 Storage - Manual (Page 137)

¢
In a two-node configuration, execute the following command to
release the cluster installation mode:
# /usr/cluster/bin/scconf -c -q reset
32
.
On all nodes in the cluster, add /opt/DynamicLinkManager/bin to the
PATH environment variable in the environment settings files (such
as .profile) for root permissions.
When the Bourne or Korn shells is used, add the path as shown below:
PATH=$PATH:/opt/DynamicLinkManager/bin ; export PATH
When the C shell is used, add the path as shown below:
set path=( $path /opt/DynamicLinkManager/bin )
33
.
Execute the following command to view the HDevName and iLU columns:
# /opt/DynamicLinkManager/bin/dlnkmgr view -path
Check the execution results of this command to determine the
correspondence between each HDevName (logical device file name of the
HDLM device) and iLU (the internal LU number). Then, compare the
correspondence of the logical device file names and internal LUs that took
place before HDLM was installed, and then re-register the correct HDLM
devices in those programs that will use these devices.
To use an HDLM-managed device with a file system created by using
volume management software, perform step 34.
To use an HDLM-managed device with a file system created without using
volume management software, perform steps 35 to 37.
34
.
Register the disk device group.
If you are using VxVM, see
Linking VxVM and Sun Cluster on page 3-168 .
If you are using SDS, see To Use a Shared Diskset on page 3-172 in
Registering HDLM Devices on page 3-171 .
If you are using SVM, see To Use a Shared Diskset on page 3-175 in
Registering HDLM Devices on page 3-175 .
35
.
In Sun Cluster, to create a new shared file system, create it in any HDLM-
managed device from a desired node.
The following shows an example of executing the command:
host1# newfs /dev/global/rdsk/d5s0
36
.
Execute the following command to create a directory for mounting on
each node:
The following shows an example of executing the command:
host1# mkdir -p /global/mntpt
host2# mkdir -p /global/mntpt
37
.
On the desired node, mount the file system. The following shows an
example of executing the command:
Creating an HDLM Environment
3-71
Hitachi Dynamic Link Manager User Guide for Solaris ®