HP XP P9500 Storage - Manual (Page 253)

Then, execute the following command at the ok prompt on all nodes:
boot -r
Note
While a node is starting, the message below may be output to the
console or syslog:
Could not stat: ../../devices/pseudo/dlmndrv@1/
dlmfdrv@0,0:c,raw path not loaded.
This message is output because HDLM is removed and the HDLM
devices are deleted. If you do not want this message to be output
next time the node starts, update the device ID information by
referring to steps 1 to 4 in Sun Cluster Settings on page 3-192 of
Settings Needed After HDLM Removal on page 3-192 . For details,
refer to the Sun Cluster documentation.
Removing HDLM from the Boot Disk Environment
1
.
Migrate to the local boot disk environment, following the procedure
described in Migrating from a Boot Disk Environment to the Local Boot
Disk Environment on page 3-110 .
2
.
Remove HDLM, following the procedure described in Removing HDLM
from the Local Boot Disk Environment on page 3-185 .
Removing HDLM from an LDoms Environment
This section explains how to remove HDLM from an I/O domain.
The following figure shows an example of configuration before HDLM is
removed.
Figure 3-32 Configuration Example (Before Removal)
#
Creating an HDLM Environment
3-187
Hitachi Dynamic Link Manager User Guide for Solaris ®