HP XP P9500 Storage User Manual

Page 353

When the confirmation message is displayed, the user enters y to

continue, or n to cancel the operation.

# /opt/DynamicLinkManager/bin/dlnkmgr online -hba 0001.0000

KAPL01057-I All the paths which pass the specified HBA will

be changed to the Online status. Is this OK? [y/n]:y

KAPL01061-I 3 path(s) were successfully placed Online; 0

path(s) were not. Operation name = online

-hbaid HBA-port-ID

Use this parameter to place online, at one time, all paths that pass

through a specific HBA port. The command will place online all paths

connected to the HBA port that has the specified HBA-port-ID. To display

the HBA port IDs, execute the following view operation:

# /opt/DynamicLinkManager/bin/dlnkmgr view -hba

For details about how to execute the view operation to display the HBA

port IDs, see

Example

The following example shows how to place online all paths connected

to the HBA port whose HBA-port-ID is 00001.

# /opt/DynamicLinkManager/bin/dlnkmgr online -hbaid 00001

KAPL01104-I All the paths which pass the specified HBA port

will be changed to the Online status. Is this OK? [y/n]:y

KAPL01061-I 15 path(s) were successfully placed Online; 0

path(s) were not. Operation name = online

-cha -pathid AutoPATH_ID

Use this parameter to place online, at one time, all the paths that pass

through a specific CHA port. The command will place online all the paths

that pass through the CHA port to which the path with the specified

AutoPATH_ID is connected.
Specify the current AutoPATH_ID of the target path, which is displayed by

using the view operation. For details on the view operation, see

. Leading zeros can be omitted

(000001 and 1 indicate the same AutoPATH_ID). Therefore, when the

target AutoPATH_ID is 000000, enter 000000 or 0 for the parameter

value.
AutoPATH_IDs are re-assigned every time the host is restarted. When you

want to add a new LU without restarting the host, AutoPATH_IDs are re-

assigned to each path of the LU when you execute the dlmcfgmgr utility

for managing the HDLM configuration. Always make sure that you execute

Command Reference

6-13

Hitachi Dynamic Link Manager User Guide for Solaris

This manual is related to the following products: