HP XP P9500 Storage - Manual (Page 284)

newly added path in HDLM, execute the dlmsetconf utility and then
restart the host, with the reconfiguration option specified.
• In Solaris 10 or Solaris 11, you can delete HDLM devices without
restarting the host. However, if you cannot stop all of the programs that
are using the HDLM devices that you want to delete or you cannot remove
the mapping between the internal LUs and the storage port LUNs by
performing operations on the storage system, you must restart the host
to delete the HDLM devices.
Adding a New Logical Unit
This section describes the operations for configuring a new LU recognized by
the host, as an HDLM-managed device.
In a Solaris 8 version1/01 or later, Solaris 9, Solaris 10, or Solaris 11
environment that supports dynamic reconfiguration of HDLM devices, you can
modify settings so that new LUs are recognized automatically by the HDLM
driver without restarting the host. In this case, you need to use the
dlmcfgmgr utility for managing the HDLM configuration in order to have the
HDLM driver recognize the contents of the HDLM driver configuration
definition file (/kernel/drv/dlmfdrv.conf) without having to restart the
host. For details on the dlmcfgmgr utility, see The dlmcfgmgr Utility for
Managing the HDLM Configuration on page 7-16 .
Notes
The following describes the notes on adding new LUs:
• If you do not want to configure an LU that was newly added to the host,
as an HDLM managed device, first set the LU as a non-HDLM-managed
device, and then execute the dlmcfgmgr utility. If the newly added LU is
set as a non-HDLM-managed device, reconfiguration of the LU for the
HDLM driver will not be performed.
• You cannot perform dynamic reconfiguration when you add a new LU to
HDLM and an existing instance number is allocated to the path of the LU.
In such a case, restart the host.
• If the major and minor numbers of the sd or ssd device of an LU to be
newly added to HDLM matches the major or minor number of an sd or ssd
device previously registered in HDLM, dynamic reconfiguration cannot be
performed. You must restart the host.
• Dynamic reconfiguration cannot be performed when using VxVM, because
the host must be restarted in order to use (in VxVM) an LU that has been
newly added to HDLM.
• After you execute the dlmcfgmgr utility to add a new LU, when you
execute the path status display command (the view -path operation),
the HDevName of the added LU may be displayed as a hyphen (-).
• If you do not specify a disk label, the dlmcfgmgr utility might take time to
complete the processing when you execute the utility.
4-22
HDLM Operation
Hitachi Dynamic Link Manager User Guide for Solaris ®