HP XP P9500 Storage - Manual (Page 123)

# DVD-ROM-mount-point/installux.sh -f /any-directory/
installation-information-settings-file
When executing the installhdlm utility
# DVD-ROM-mount-point/HDLM_Solaris/installhdlm -f/any-
directory/installation-information-settings-file
If execution of the utility is completed without problems, the
KAPL09211-I message is output.
If the restart key is set to y (to restart the computer) in the
installation-information settings file, make sure that the KAPL09211-I
message has been output to the installhdlm.log file specified by
the logdir key.
After confirming that the KAPL09211-I message has been output,
execute the following command to delete the installation-information
settings file:
# rm -r /any-directory/installation-information-settings-
file
If the driver_config key is set to n (so that the dlmsetconf utility is
not executed) in the installation-information settings file, go to step 9.
If the restart key is set to n (so that the computer is not restarted)
in the installation-information settings file, go to step 11.
If the restart key is set to y (to restart the computer) in the
installation-information settings file, go to step 14.
7
.
Continue by following the instructions displayed on the screen.
If the license key file named /var/tmp/hdlm_license is not saved, a
message, showing whether a user-specified license key file has been
saved, is output. Enter 1 if a user-specified license key file has been
saved. Enter 2 if a license key is specified directly.
¢
Note that if any value other than 1 or 2 is entered three times, the
installation is stopped.
If 1 is entered, specify a user-specified license key file with the absolute
path.
¢
Note that if the wrong absolute path is entered three times, the
installation is stopped.
If 2 is entered, a message that prompts you to enter a license key is
displayed. Enter the license key.
¢
When a correct license key is entered, the installation program
displays a message that indicates the license was installed.
¢
Take care that if you enter an incorrect license key three times,
installation stops.
If you interrupt an installation, check whether the /var/opt/
DynamicLinkManager directory exists.
If the /var/opt/DynamicLinkManager directory exists, execute the
following command to delete it:
Creating an HDLM Environment
3-57
Hitachi Dynamic Link Manager User Guide for Solaris ®