HP StorageWorks 2.64 Director Switch User Manual
Page 67

Director Element Manager user guide
67
A Port Binding error may be due to an invalid WWN or nickname entry in the Configure Ports
dialog box in the Bound WWN column. See ”
” on page 97 for a description
of the Configure Ports dialog box.
Reason messages for an invalid attachment can include:
•
0x0C ESA Security Mismatch
—Security features do not match.
•
0x0D Fabric Binding Mismatch
—Fabric Binding is enabled and detected a
connection with a switch or director with an incompatible fabric membership list.
•
0x0E Authorization Failure Reject
—The switch or director on the other side of
an ISL detected a security violation. Your switch received notification via a generic reject
code and sets its port to the invalid attachment state in sympathy.
•
0x0F Unauthorized Switch Binding WWN
—A Switch Binding error was detected on
either an E_Port or an F_Port.
•
0x10 Authentication Failure
—ISL Authentication Check (CHAP) failed.
•
0x11 Fabric Mode Mismatch
—A connection was not allowed because:
• An HP M-Series switch or director attempted to connect to an HP switch or director
running in Open Fabric mode.
• An HP M-Series switch or director running in Open Fabric mode attempted to connect to
another vendor’s switch or director with an incorrect exchange link protocol (ELP)
revision level.
•
0x12 CNT WAN Extension Mode Mismatch
—The ELP maximum frame sizes were
incompatible because one product running in CNT WAN extension mode attempted to
connect to another product running in a normal mode.
•
01 Unknown
—The reason is not known.
•
02 ISL connection not allowed on this port
—ISL is connected to a port
configured as an F_Port.
•
03 ELP rejected by the attached switch
—This director transmitted an exchange
link protocol (ELP) frame that was rejected by the switch at the other end of the ISL.
•
04 Incompatible switch at other end of the ISL
—The switch is configured
for Homogenous Fabric mode, and the switch at the other end of the ISL is an HP switch
configured for Open Fabric 1.0 mode.
•
05 External loopback adapter connected to the port
—A loopback plug is
connected to the port, and no diagnostic test is running.
•
06 N_Port connection not allowed on this port
—The port type configuration
does not match the actual port use (the port is configured as an E_Port, but attaches to a
node device).
•
07 Non_HP switch at other end of the ISL
—The cable is connected to a non-HP
switch, and interop mode is set to Fabric 1.0 mode.
•
08 ISL connection not allowed on this port
—The port type configuration
does not match the actual port use (the port is configured as an F_Port, but attaches to a
director or switch).