HP StorageWorks 2.64 Director Switch - Manual (Page 180)

Information and error messages 180
Remote session support has been
disabled.
The connection between the specified
remote workstation and the HAFM
appliance was disallowed.
Consult with the customer’s network
administrator to determine if the
workstation entry should be modified at the
Remote Access dialog box.
Resource is unavailable. The specified operation cannot be
performed because the product is
unavailable.
Verify the HAFM appliance-to-product link
is up. If the link is up, the HAFM appliance
may be busy. Try the operation again
later.
Route data corrupted. The information for this route is
corrupt.
Try the operation again. If the problem
persists, contact the next level of support.
Route request timeout. The Show Route request timed out. Try the operation again. If the problem
persists, contact the next level of support.
Routing is not supported by the
switch.
This switch or director does not
support the Show Routes feature.
Select a different switch or director to show
the route.
SANtegrity Feature not installed.
Please contact your sales
representative.
You selected Fabric Binding or
Enterprise Fabric Mode from
the Fabrics menu. These selections
are not enabled because the
optional SANtegrity binding feature
is not installed.
Install the SANtegrity Binding feature to
use Fabric Binding or enable Enterprise
Fabric Mode.
Select alias to add to zone. An alias was not selected before
clicking Add.
Select an alias before clicking Add.
Selection is not a World Wide
Name.
The selection made is not a World
Wide Name.
Select a valid World Wide Name before
performing this operation.
Server shutting down. The HAFM application is closing and
terminating communication with the
attached product.
Reboot the HAFM appliance. If the
problem persists, contact the next level of
support.
SNMP trap address not defined. If an SNMP community name is
defined, a corresponding SNMP trap
recipient address must also be
defined.
Enter a corresponding SNMP trap recipient
address.
Switch is not managed by HAFM. The selected switch or director is not
managed by the HAFM application.
Select a different switch or director.
The Administrator user cannot be
deleted.
The administrator user is permanent
and cannot be deleted from the
Configure Users dialog box.
Informational message only—no action is
required.
The director did not handle the
request
The director did not complete the
action.
Try again. If the problem persists, contact
your support representative.
The director is busy saving
maintenance information.
The director is busy with a
maintenance operation.
Try again. If the problem persists, contact
your support representative.
Table 9 HAFM messages (continued)
Message Description Action