HP StorageWorks 2.64 Director Switch - Manual (Page 179)

Director Element Manager user guide 179
No attached nodes selected. An operation was attempted without
an attached node selected.
Select an attached node and try the
operation again.
No management server specified. An HAFM appliance is not defined to
the HAFM application.
At the HAFM 8 Log In dialog box, type an
appliance name in the Server Name field
and click Login.
No nickname selected. No nickname was selected when the
command was attempted.
Select a nickname and try again.
No Element Managers installed. No director or switch Element
Manager is installed on this
workstation.
Install the appropriate Element Manager to
this workstation.
No routing information available. No information is available for the
route selected.
Select a different route and try the
operation again.
No user selected. A user was not selected when the
command was attempted.
Select a user and try again.
No zone member selected. A zoning operation was attempted
without a zone member selected.
Select a zone member and try the
operation again.
No zone selected. A zoning operation was attempted
without a zone selected.
Select a zone and try the operation again.
No zone selected or zone no
longer exists.
A zoning operation was attempted
without a zone selected, or the zone
selected no longer exists in the fabric.
Select a zone and try the operation again.
No zone set active. A zone set cannot be deactivated if
there are no active zones.
Informational message only—no action is
required.
No zone set selected. A zoning operation was attempted
without a zone set selected.
Select a zone set and try the operation
again.
No zone set selected or zone set no
longer exists.
A zoning operation was attempted
without a zone set selected, or the
zone set you selected no longer exists
in the fabric.
Select a zone set and try the operation
again.
Only attached nodes can be
displayed in this mode.
You cannot display unused ports
when adding ports by World Wide
Name.
Change the add criteria to Add by Port.
Password and confirmation don’t
match.
Entries in the password field and
confirmation password field do not
match. The entries are case sensitive
and must be the same.
Enter the password and confirmation
password again.
Remote sessions are not allowed
from this network address.
Only IP addresses of remote
workstations specified at the Remote
Access dialog box are allowed to
connect to the HAFM appliance.
Consult with the customer’s network
administrator to determine if the IP address
is to be configured for remote sessions.
Table 9 HAFM messages (continued)
Message Description Action