Ficon management server, Features, Date and time – HP StorageWorks 2.64 Director Switch User Manual
Page 28: Threshold alert(s)

Overview
28
•
Host Control Prohibited—Select this check box to display a check mark and prohibit the host
management program from changing configuration and connectivity parameters on the director.
In this case, the host program has read-only access to configuration and connectivity
parameters.
FICON Management Server
This option only displays if the FICON Management Server inband management feature was
enabled through the Configure Feature Key dialog box. (See ”
page 113 for more information.) You can select the following suboptions:
•
Enable FICON Management Server—Select the check box to display a check mark and enable
the FICON Management Server.
•
Parameters—Select this option to display the Configure FICON Management Server dialog
box. Use this dialog box to perform the following tasks:
• Allow or prohibit director clock alert mode.
• Allow or prohibit programmed offline state control.
• Select a code page from the Code Page drop-down list.
For details, see ”
Features
This option displays the Configure Feature Key dialog box. Use this dialog box to enter a feature key
to enable optional features that you have purchased for the director. (See ”
” on page 113 for more information.)
Date and Time
Select this option to display the Configure Date and Time dialog box. Use this option to set the
current date and time in the director. When the Periodic Date/Time Synchronization check box is
checked, the Date and Time fields are grayed out (disabled), and the HAFM appliance’s date and
time periodically synchronizes the director date and time. If the Periodic Date/Time Synchronization
check box is not checked, you can set the date and time in the dialog box fields manually.
Threshold Alert(s)
Select this option to configure threshold alerts for ports. A threshold alert notifies users when the
transmit (Tx) or receive (Rx) throughput reaches specified values for specific director ports or port
types (E_Ports or F_Ports). Using this option, you can configure:
•
A name for the alert.
•
A threshold type for the alert (Rx, Tx, or both).
•
Active or inactive state of the alert.
•
Threshold criteria. This includes configuring the threshold as the percent of port traffic capacity
utilized (% utilization). You must also configure the time interval during which the throughput is
measured and the maximum cumulative time that the throughput percentage threshold can be
exceeded during this time interval before an alert is generated.