HP StorageWorks 2.64 Director Switch - Manual (Page 184)

Information and error messages 184
Zones must be defined before
creating a zone set. You cannot create a zone set without
any zones defined for HAFM. Define zones using the New Zone dialog
box.
Zoning by port number is ignored
in Open Fabric Mode. While in Open Fabric mode, zones
configured using port numbers are
enforced through World Wide
Names. Informational message only–no action is
required.
Zoning by port number is not
supported in Open Fabric Mode. You cannot specify an item for
zoning by port number if HAFM is in
Open Fabric Mode. Either define zones by WWN of device or
change to Homogeneous Fabric mode in
the Configure Operation Mode dialog box
of the Element Manager.
Zoning name already exists. Duplicate zone names are not
allowed in the zoning library. Modify (to make it unique) or delete the
duplicate zone name.
Table 9 HAFM messages (continued)
Message Description Action