HP StorageWorks 2.64 Director Switch - Manual (Page 152)

Optional features 152
2. Click Add to configure a new preferred path. The Add Preferred Path dialog box appears as
shown in Figure 69 .
Figure 69 Add Preferred Path dialog box
3. Click the drop-down lists for the Source Port, Exit Port, and Destination Domain ID to make your
choices. See ” Exporting the configuration report ” on page 122 for more information.
TIP: You can also enter an exit port number for future or offline environments.
4. Click OK. The new route will be added to the table on the Configure Preferred Paths dialog
box. The configuration will be validated.
5. Select the Enable Preferred Paths check box in the Configure Preferred Paths dialog box to
enable the configured preferred paths. When this option is not selected, the preferred path
configurations are not enforced, but the configured paths are retained for future use.
6. Click Activate.
Changing a preferred path
To change a preferred path, use the following steps:
1. Select Configure > Preferred Path. The Configure Preferred Paths dialog box appears as shown
in Figure 68 .
2. To change a preferred path, select the path you want to change and click Change. The Change
Preferred Path dialog box appears.
3. Change the data as required.
4. Click Activate. The data will be changed in the table on the Configure Preferred Paths dialog
box.
5. Click the Enable Preferred Paths check box in the Configure Preferred Path to enable the
configured preferred paths. When this option is not selected, the preferred path configurations
are not enforced, but the configured paths are retained for future use.
6. Click Activate.
Removing a preferred path
To remove a new preferred path, use the following steps:
1. Select Configure > Preferred Path. The Configure Preferred Paths dialog box appears as shown
in Figure 68 .
2. Select the path you want to remove and click Remove.
3. Click Activate.