HP StorageWorks 2.64 Director Switch - Manual (Page 190)

Information and error messages 190
Cannot set director state. The director state cannot be set
because the link is down or busy. Retry the operation later. If the condition
persists, contact the next level of support.
Cannot set Fibre Channel
parameters. Fibre Channel parameters for the
director cannot be set at the Element
Manager because the Ethernet link is
down or busy. Retry the operation later. If the condition
persists, contact the next level of support.
Cannot set switch date and time. The switch date and time cannot be
set at the Element Manager because
the Ethernet link is down or busy. Retry the operation later. If the condition
persists, contact the next level of support.
Cannot set switch state. The director or switch state cannot be
set at the Element Manager because
the Ethernet link is down or busy. Retry the operation later. If the condition
persists, contact the next level of support.
Cannot set write authorization
without defining a community
name. A community name was not defined
in the Configure SNMP dialog box for
the write authorization selected. Provide a name in the Name field where
write authorization is checked.
Cannot start data collection. The data collection procedure cannot
be started by the Element Manager
because the Ethernet link is down or
busy. Retry the operation later. If the condition
persists, contact the next level of support.
Cannot start firmware install while
CTP synchronization is in progress. The director’s CTP cards are
synchronizing and firmware cannot
be installed until synchronization is
complete. Install the firmware after CTP card
synchronization completes.
Cannot start port diagnostics. Port diagnostics cannot be started at
the Element Manager because the
Ethernet link is down or busy. Retry the operation later. If the condition
persists, contact the next level of support.
Cannot swap an uninstalled port. A port swap cannot be performed
when the port card is not installed. Perform a swap only on a port that is
installed.
Click OK to remove all contents
from log. This action deletes all contents from
the selected log. Click OK to delete the log contents or click
Cancel to cancel the operation.
Connection to management server
lost. Click OK to exit application. The HAFM application at a remote
workstation lost the network
connection to the HAFM appliance.
Start the HAFM application to connect to
the HAFM appliance.
Continuing may overwrite host
programming. Continue? Configurations sent from the host may
be overwritten by HAFM. Continuing will activate the current
configuration, which may have been
configured by a FICON host.
Table 10 Element Manager messages (continued)
Message Description Action