HP OneView - Manual (Page 293)

Create logical interconnect group General V
General
?
Name Enclosure 2LIG
Logical Interconnect Group
FCUS3 X
1 network
2 uplink ports
X X X
1 network
2 uplink ports
FCUS4
2 uplink ports
devUS
1 network
2 uplink ports
testUS
1 network
Add uplink set
Add Interconnect Add Interconnect
interconnect 1
1
3
2
1 2 3 4
Q1
X1 X2 X3 X4 X5 X6 X7 X8 X9 X10
1 2 3 4
Q2
1 2 3 4
Q3
1 2 3 4
Q4
HP VC FlexFabric 20/40 F8 Module
interconnect 2
1 2 3 4
Q1
X1 X2 X3 X4 X5 X6 X7 X8 X9 X10
1 2 3 4
Q2
1 2 3 4
Q3
1 2 3 4
Q4
HP VC FlexFabric 20/40 F8 Module
Create Create + Cancel
1
Changed: Name to “Enclosure2LIG”
4. Click Create to create the logical interconnect group.
A.5.5 Creating an enclosure group for enclosure 1
An enclosure group defines a set of enclosures that use the same configuration for network
connectivity. The network connectivity for an enclosure group is defined by the logical interconnect
group associated with the enclosure group.
Create an enclosure group that captures the logical interconnect group and its uplink configuration:
1.
From the main menu , select Enclosure Groups, and click Create enclosure group.
The Create enclosure group dialog box appears.
2. For Name, enter EncGrp1.
3. For Logical interconnect group, select Enclosure1LIG.
4. Click Create.
A.5.6 Adding enclosure 1
Adding an enclosure brings the rack, the enclosure, and the enclosure's contents—server hardware
and interconnects—under managed control. You add an enclosure by providing its IP address or
host name, along with the enclosure's Onboard Administrator credentials. In this procedure, you
will also establish a firmware baseline for the enclosure.
NOTE: The name associated with the enclosure is the enclosure name, which is set in the Onboard
Administrator, and is not the name of the Onboard Administrator.
In this procedure you will add one enclosure:
Description Attribute
198.51.100.251 Enclosure 1 primary Onboard Administrator IP
address
User name OAAdmin
Password S&leP@ssw0rd
Onboard Administrator credentials (same for both
enclosures)
1. From the main menu , select Enclosures and click Add enclosure.
The Add Enclosure dialog box opens.
A.5 Provisioning eight host servers for VMware vSphere Auto Deploy 293