HP OneView - Manual (Page 286)

5. Create the network set for the test networks:
a.
For Name, enter test networks and click Add networks.
The Add Networks to test networks dialog box opens.
b. In the search box, enter test to filter the list of networks.
c. Select all of the test networks listed and click Add.
d. Select Untagged for the first network in the list of networks.
e. Click Create.
The Network Sets screen opens. As shown in the following illustration, if you select a network
set in the
master pane , the appliance displays details about that network set in the details
pane.
Network Sets 3
All labels
Create network set
Overview test networks
General
Networks
Preferred bandwidth 2.5 Gb/s
10 Gb/s
none
Maximum bandwidth
Used by
test_1111 test_1114 Untagged
test_1112
test_1113
V
Reset V
Actions
V
Name
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
prod networks
dev networks
test networks
4
V
1111
1112
1113
1114
A.5.4 Creating a logical interconnect group and its uplink sets
You can create logical interconnect groups, including their uplink sets, and their associated enclosure
groups in different ways:
•
You can create them before you add enclosures to the appliance.
•
You can create them during the enclosure add operation.
In the following procedures, you will define the groups before you add any enclosures. Choose
from:
•
“Creating a logical interconnect group for enclosure 1” (page 286)
•
“Creating a logical interconnect group for enclosure 2” (page 290)
A.5.4.1 Creating a logical interconnect group for enclosure 1
In this procedure, you will create a logical interconnect group for the first enclosure. It contains an
HP VC FlexFabric 10Gb/24-Port Module and an HP VC 8Gb 20–Port FC Module.
Creating the logical interconnect group
1. From the main menu , select Logical Interconnect Groups and click + Create logical interconnect
group.
The Create logical interconnect group dialog box opens. The large boxes on the screen
represent enclosure interconnect bays, with bays 1 and 2 in the top row, bays 3 and 4 in the
next row, and so forth. Only interconnects of the same model can be installed in horizontally
adjacent bays.
2. For Name, enter Enclosure1LIG.
286 Step by step: Configuring an example data center using HP OneView