HP OneView - Manual (Page 288)

5. Add the uplink set for FC 2:
a.
For Name, enter FCUS2.
b. For Type, select Fibre Channel.
c. For Network, select FC 2.
d. Configure the uplink ports. For Interconnect under Uplink Ports, select Interconnect: 4 and
then select ports X3 and X4.
e. Click Create.
NOTE: Networks FC 3 and FC 4 will be added to enclosure 2.
The Create logical interconnect group dialog box opens.
See the following illustration for an example.
Create logical interconnect group General
V
General
Logical Interconnect Group
Name Enclosure 1LIG
1 network
X
2 uplink ports Add uplink set
X
2 uplink ports
FCUS1 FCUS2
1 network
X1 X2
interconnect 1
HP VC FlexFabric 10Gb/24-Port Module
X3 X4 X5 X6 X7 X8 X1 X2
interconnect 2
HP VC FlexFabric 10Gb/24-Port Module
X3 X4 X5 X6 X7 X8
?
1
2
1 2 3 4 1 2 3 4
HP VC 8Gb 20-Port FC Module
interconnect 4
HP VC 8Gb 20-Port FC Module
3
4
interconnect 3
Create Create + Cancel
Creating the uplink sets for the Ethernet networks
The uplink sets assign data center networks to physical interconnect ports.
TIP: If you click Cancel on the Create Logical Interconnect Group dialog box, all changes are
discarded.
Instead of adding all of the uplink sets in one session, you can click Create to create the logical
interconnect group, and then edit the logical interconnect group to add additional uplink sets.
1. Click Add uplink set.
The Add uplink set screen opens.
2. Configure the uplink set for the Ethernet networks:
a.
For Name, enter vsphereUS.
b. For Type, select Ethernet.
The dialog box expands to include additional configuration items.
c. For Connection Mode, select Automatic.
The default value, automatic, instructs the system to determine the best load-balancing
scheme by creating as many LAGs (link aggregation groups) as possible in a physical
interconnect, enabling multiple links to behave as a single link.
d. For LACP timer, use the default value.
288 Step by step: Configuring an example data center using HP OneView