HP OneView - Manual (Page 254)

Possible cause and recommendation Symptom
The server hardware or its iLO are powered-off or reset
•
In most cases, retrying the operation resolves the problem
The appliance cannot collect progress information from the iLO
•
In most cases, retrying the operation resolves the problem
A profile operation
timeout when
applying BIOS
settings
Invalid configuration
• Auto-assignment for FlexNIC connections does not validate the following:
◦
Bandwidth oversubscription on the physical port
◦
Maximum networks (VLANs) on the physical port
◦
Duplicate networks (VLANs) on the physical port
•
Manual assignment is required
Auto-assignment for
FlexNIC fails while
deploying
connections
31.15.2 What to do when you cannot apply the server profile
Possible cause and recommendation Symptom
If you cannot apply the server profile because the PXE boot does not boot within the expected
amount of time, reset the iLO. Cannot apply the
server profile
Verify the operational status of the server hardware
1. Click Cancel to exit from the Create Server Profile screen.
2. From the main menu, navigate to the Server Hardware screen.
3. Find, and then select the server hardware.
Cannot verify the
status of the server
hardware
254 Troubleshooting