HP OneView - Manual (Page 91)

8 Planning for configuration changes
This chapter identifies configuration changes that might result in a resource being taken offline
temporarily or that might require that you make changes to multiple resources.
8.1 Configuration changes that require or result in resource outages
Appliance
Taking an appliance offline does not affect the managed resources—they continue to operate while
the appliance is offline.
When you install an appliance update, the appliance is taken offline.
Enclosures
The Onboard Administrator (OA) is taken offline when you update firmware for an enclosure.
Interconnects and logical interconnects
•
Server profile connections to networks in an uplink set are taken offline when you delete the
uplink set.
•
Server profile connections to networks in an uplink set can be interrupted for a few seconds
when you change the name of an uplink set using either of these methods:
◦ Change the name of the uplink set in the logical interconnect.
◦
Change the name of the uplink set in the logical interconnect group, and then update the
logical interconnect from the logical interconnect group.
•
An interconnect is taken offline when you:
Update or activate firmware for a logical interconnect. Staging firmware does not require
interconnects be taken offline. ◦
◦
Update firmware for an enclosure and select the option to update the enclosure, logical
interconnect, and server profiles.
•
If an interconnect has firmware that has been staged but not activated, any subsequent reboot
of that interconnect activates the firmware, which takes the interconnect offline.
•
You can prevent the loss of network connectivity for servers connected to a logical interconnect
that has a stacking mode of Enclosure and a stacking health of Redundantly Connected
by updating firmware using the following method:
1.
Staging the firmware on the logical interconnect.
2. Activating the firmware for the interconnects in even-numbered enclosure bays.
3. Waiting until the firmware update to complete and the interconnects are in the
Configured
state.
4. Activating the firmware for the interconnects in the odd-numbered enclosure bays.
Networks
•
If you attempt to delete a network that is in use by one or more server profiles, the appliance
warns you that the network is in use. If you delete the network while it is in use, server profile
connections that specify the network explicitly (instead of as part of a network set) are taken
offline.
If you add a network with the same name as the network you deleted, connections that specify
the network explicitly (instead of as part of a network set) are not updated—you must edit
8.1 Configuration changes that require or result in resource outages 91