NORD Drivesystems BU0180 - Manual (Page 75)

6 Parameterisation
BU 0180 GB-0914 Pre-series version 75
Exampl
e il
lustr
atio
n
6 Parameterisation
The frequency inverter, field bus and I/O -extension modules each have their own logic systems. These can
be adapted to customers' requirements by means of changeable parameters. The basic functions of the
particular modules are factory-set, so that the units have basic functionalities on delivery. Limited
adaptations of individual functions of the relevant devices can be implemented vie DIP switches. For all
further adjustments, access to the parameters of the relevant device with the aid of a ParameterBox
(SK PAR-3H, SK CSX-3H) or NORD CON software is essential. It should be noted that the hardware
configuration (DIP - switches) has priority over configuration via software (parameterisation).
NOTE: For use on the SK 1x0E the ParameterBox SK PAR-3H must have at least the software
version 4.4 R2.
The following describes the relevant parameters for the frequency inverter (Section 6.1) and the I/O
extension modules (Section 6.2). Explanation for parameters which relate to the field bus options can be
obtained from the relevant supplementary manuals.
Availability of the parameters
Due to certain configurations, the parameters are subject to certain conditions. The following tables (from
Section 6.1 onwards) list all parameters together with the particular information.
Array parameter display
Some parameters have the option of displaying settings and views in several levels (arrays). After the
parameter is selected, the array level is displayed and must then also be selected.
Parameter set dependent (P) parameter selections in P100
Parameter number
Parameter text
Top: P-Box display
Bottom: Meaning
Supervisor parameters (S)
Depend on the setting in P003
Array value
Parameter value range
Factory settings of parameter
e.g. only available for size 2 is relevant
Description