NORD Drivesystems BU0180 - Manual (Page 40)

SK 180E Manual for frequency inverters
40 Pre-series version BU 0180 GB-0914
Assembly
Mounting of a plug connector on the housing of the frequency inverter is usually only possible with a con-
nection adapter (connection extension SK TIE4-HAN10E).
Plug connector* Part. No. Technical data plus
SK TIE4-HAN10E
(275274100)
HAN 10E LA 2BUE
(Power output)
275135010 Add-on housing with 2-clamp lock, socket insert 10-pin. + PE,
spring terminals, PE: Screw connection,
electrical data: 16A 500V
X
HAN 10E LE 1BUE
(Power input)
275135070 Add-on housing with 1-clamp lock, pin insert 10-pin. + PE,
spring terminals, PE: Screw connection,
electrical data: 16A 500V
X
HAN 10E LE 2BUE
(Power input)
275135000 Add-on housing with 2-clamp lock, pin insert 10-pin. + PE,
spring terminals, PE: Screw connection,
electrical data: 16A 500V
X
HAN 10E MA 2BUE
(Motor output)
275135020 Add-on housing with 2-clamp lock, socket insert 10-pin. +
PE, spring terminals, PE: Screw connection,
electrical data: 16A 500V
X
HQ8 LA
(Power output)
275135040 Add-on housing, socket insert 8-pin. + PE,
crimp connection, electrical data: 16A 500V X
HQ8 LE
(Power input)
275135030 Add-on housing, pin insert 8-pin. + PE, crimp connection,
electrical data: 16A 500V X
HQ8 MA
(Motor output)
275135050 Add-on housing, socket insert 8-pin. + PE,
crimp connection, electrical data: 16A 500V X
Connection
extension HAN Q5
(Power input +
motor or power
output)
275274110 2 x add-on housing on a connector frame, each with one
5-pin pin insert + PE and a 5-pin socket insert + PE, crimp
connection, PE: Screw connection,
electrical data: 16A, 230V/400V
Not required!
* Further types available on request
The connection extension SK TIE4-HAN10E contains all the additional elements required for the HAN 10E
and HAN Q8 versions listed above. Installation is recommended as follows. Steps 2 and 3 are not required
for plug version HAN Q5.
Step 1 Step 2 Step 3 Step 4 Step 5
Disassembly of the
2 x M25 blank plug Put on seal Put on adapter plate Install the add-on
plug housing with
screws and contact
washers Make the electrical
connections