NORD Drivesystems BU0180 - Manual (Page 128)

SK 180E Manual for frequency inverters
128 Pre-series version BU 0180 GB-0914
Parameter Setting value / Description / Note Device Supervisor
Parameter
set
P705 [-01]
...
[-05]
DC-Link Voltage previous error
1...5
(DC-Link Voltage previous error 1...5)
S
0 ... 1000 V DC This parameter stores the link voltage that was being delivered at the time the error occurred.
The values of the last 5 errors are stored.
With the SimpleBox, the corresponding memory location 1...5- (Array parameter) must be
selected and confirmed using the OK key to read the stored error code.
P706 [-01]
...
[-05]
P-set prev. error 1...5
(Parameter set, previous error 1...5)
S
0 ... 3 This parameter stores the parameter set code that was active when the error occurred. Data for
the previous 5 faults are stored.
With the SimpleBox the corresponding memory location 1...5 (Array parameter), must be
selected and confirmed with the ENTER key in order to read the stored error code.
P707 [-01]
...
[-03]
Software version
(Software version/ revision)
0.0 ... 9999.9 This parameter shows the software and
revision numbers in the FI. This can be
significant when different FIs are assigned
the same settings.
Array [-03] provides information about any
special versions of the hardware or
software A zero stands for the standard
version.
[-01] = Software version,Version number (V1.0)
[-02] = Software revision, Revision number (R1)
[-03] = Special version, of the
hardware/software (0.0)
P708
State of digital in.
(Status of digital input)
00000 ... 11111 (bin)
or
0000 ... FFFF (hex)
Displays the status of the digital inputs in binary/hexadecimal code. This display can be used to
check the input signals.
Bit 0 = Digital input 1
Bit 1 = Digital input 2
Bit 2 = Digital input 3 Bit 3 = Digital input 4
Bit 4 = Digital input 5
Bit 5 = Thermistor input
Bits 6 - 7 reserved
First SK xU4-IOE (optional)
Bit 8 = 1st IO extension: Digital input 1
Bit 9 = 1st IO extension: Digital input 2
Bit 10 = 1st IO extension: Digital input 3
Bit 11 = 1st IO extension: Digital input 4 Second SK xU4-IOE (optional)
Bit 12 = 2nd IO extension: Digital input 1
Bit 13 = 2nd IO extension: Digital input 2
Bit 14 = 2nd IO extension: Digital input 3
Bit 15 = 2nd IO extension: Digital input 4
Bits 15-12 Bits 11-8 Bits 7-4 Bits 3-0
Minimum value
0000
0
0000
0
0000
0
0000
0
Binary
hex
Maximum value
1111
F
1111
F
0011
3
1111
F
Binary
hex
SimpleBox: The binary bits are converted to a hexadecimal value and displayed.
ParameterBox: The bits are displayed with increasing values from right to left (binary).