NORD Drivesystems BU0180 - Manual (Page 147)

7 Status messages
BU 0180 GB-0914 Pre-series version 147
7.2.2 Table of possible error messages in the I/O extension module
Error number
Fault
Text in the ParameterBox
Cause
Remedy Group Details in
P170
E1000 1000 EEPROM error EMC interference on the SPI bus
Module faulty
1030 System bus OFF Check connections and supply cables
Ensure 24 V voltage supply
Check bus master.
E2000 2000 DIP changed DIP switch configuration changed during operation
2001 DIP configuration incorrect Illegal DIP switch setting
Check DIP switch setting. Note coding of analog inputs and
outputs!
2010 Analog output error Check switching of 10V reference voltage
Short circuit of analog output
Analog output overload (max. 10 mA)
Calibration error (P152)
A range error has occurred during measurementof the
correction values
The measured values could not be saved in the
EEPROM
2020 Inverter does not support
SK xU4-IOE
The connected frequency inverter does not support the
IO extension.
(Fault not associated with SK 1x0E possible)