NORD Drivesystems BU0180 - Manual (Page 130)

SK 180E Manual for frequency inverters
130 Pre-series version BU 0180 GB-0914
Parameter Setting value / Description / Note Device Supervisor
Parameter
set
P715
Running time
(Enablement time)
0.00 ... ___ h This parameter shows the time for which the FI was enabled and supplied current to the output.
P716
Actual frequency
(Actual frequency)
-400.0 ... 400.0 Hz Displays the actual output frequency.
P717
Actual speed
(Actual rotation speed)
-9999 ... 9999 rpm Displays the actual motor speed calculated by the FI.
P718 [-01]
...
[-03]
Current set freq.
(Actual setpoint frequency)
-400.0 ... 400.0 Hz Displays the frequency specified by the setpoint.
[-01] = Actual setpoint frequency from the setpoint source
[-02] = Actual setpoint frequency after processing in the FI status machine
[-03] = Actual setpoint frequency after frequency ramp
P719
Actual current
(Actual current)
0.0 ... 999.9 A Displays the actual output current.
P720
Act. torque current
(Actual torque current)
-999.9 ... 999.9 A Displays the actual calculated torque-developing output current (active current). Basis for
calculation are the motor data P201...P209.
 negative values = generator,  positive values = drive
P721
Actual field current
(Actual field current)
-999.9 ... 999.9 A Displays the actual calculated field current (reactive current). Basis for calculation are the motor
data P201...P209.
P722
Actual voltage
(Actual voltage)
0 ... 500 V Displays the actual AC voltage supplied by the FI output.
P723
Voltage -d
(Actual voltage component Ud)
S
-500 ... 500 V Displays the actual field voltage component.
P724
Voltage -d
(Actual voltage component Ud)
S
-500 ... 500 V Displays the actual torque voltage component.
P725
Actual cos phi
(Actual cos

)
0.00 ... 1.00 Displays the actual calculated cos

of the drive.
P726
Apparent power
(Apparent power)
0.00 ... 99.99 kVA Displays the actual calculated apparent power. Basis for calculation are the motor data
P201...P209.