2 overview of external control devices – NORD Drivesystems BU0180 User Manual
Page 64
SK 180E Manual for frequency inverters
64
Pre-series version
BU 0180 GB-0914
4.2 Overview of external control devices
All parameters can be easily accessed for reading or editing by means of an optional SimpleBox or
ParameterBox. The changed parameter data are stored in the non-volatile EEPROM memory.
In addition, up to 5 complete frequency inverter data sets can be saved in the ParameterBox and then
recalled.
The connection between the SimpleBox or ParameterBox and the SK 1x0E is made with an RJ12-RJ12
cable.
NOTE: For use on the SK 1x0E the ParameterBox SK PAR-3H must have at least the software
version 4.4 R2.
Module
Description
Data
SimpleBox
Handheld
SK CSX-3H
Used (exclusively) for commissioning,
parameterisation, configuration and control
of the frequency inverter. Storage of the
parameters is not possible.
Manual BU 0040
4-digit, 7-segment LED display
IP20
RJ12-RJ12 cable
((for connection to FI)
Part. No. 275281013
ParameterBox
Handheld
SK PAR-3H
Used for commissioning, parameterisation,
configuration and control of the frequency
inverter and its options (SK xU4-
…). Saving
of parameters is possible.
Manual BU 0040
4 digit back-lit LCD display, keyboard
Stores up to 5 complete FI data sets
IP20
RJ12-RJ12 cable (
for connection to FI / Option)
USB-Cable
(For connection to PC)
Part. No. 275281014
Mounting of the control unit on the frequency inverter:
Installation of the control unit is performed as follows:
1. Remove the blind plug from the cable gland.
2. Connect the RJ12-RJ12 cable between the control unit and
the frequency inverter.
3. After commissioning the blind plug must be replaced and
care must be taken that there is a tight seal before regular
operation is started.
4. As long as the cable gland is open, take care that no dirt or
moisture enters the device.