Yokogawa Value Series FX1000 - Manual (Page 251)

12-2
IM 04L21B01-01EN
12.2 Installation Procedure
Use a steel panel that is 2 mm to 26 mm thick.
1. Insert the FX through the front of the panel.
2. Mount the FX to the panel using the included mounting brackets as shown in the
figure below.
• Use two mounting brackets to support the top and bottom or the left and right
sides of the case (remove the stickers that are covering the holes before you
attach the brackets).
• Follow the procedure below to mount the FX to the panel.
• First, attach the two mounting brackets and temporarily tighten the mounting
screws.
• Next, fix the FX in place by tightening the mounting screws with the
appropriate torque. When the FX is approximately perpendicular to the panel,
press the mounting brackets so that they are in contact with the case, and
fully tighten the mounting screws.
• Tighten the mounting bracket screws until you hear clicks.
CAUTION
• Using more than the appropriate torque to tighten the screws can deform the case
or damage the brackets.
• Be sure not to insert foreign objects or tools into the case through the mounting
bracket holes.
• Do not touch the screw at the top of the mounting bracket (A). Loosening or
tightening this screw may cause the FX to malfunction.
Panel Mounting Diagram
Front
Panel
Panel
Mounting bracket Mounting bracket
Torque driver
(Phillips or flat blade)
Mounting screw
FX case
Attach firmly
(In the figure, the mounting brackets are used on the top and bottom of the case.)
Mounting screw
Screws temporarily fastened Fixed
Rubber packing for dust
and water protection
(except side-by-side
mounting)
A
Note
To achieve sufficient dust proofing and waterproofing, attach the included rubber packing to the
FX, and then mount the FX in the middle of the panel cut out.
However, do not use the rubber packing if you are mounting two instruments side by side or
one on top of the other.