beautypg.com

Yokogawa Value Series FX1000 User Manual

Page 231

background image

10-6

IM 04L21B01-01EN

Communication Application Errors

Errors Related to E-mail and Web Server

260

IP address is not set or ethernet function is not available.

The IP address is not specified.
Check the IP address.
See section 1.3 in the communication manual.

261

SMTP server is not found.

Occurs when the SMTP server is specified by name.
• Check the DNS setting.
• Check the SMTP server name.
See sections 1.3 and 1.4 in the communication manual.

262

Cannot initiate E-mail transmission.

• The host name of the FX is not correct. Check the host

name.

• The port number of the SMTP server is not correct.

Check the port number.

See sections 1.3 and 1.4 in the communication manual.

263

Sender’s address rejected by the server.

Check the sender’s address.
Section 1.4 in the communication manual

264

Some recipients’ addresses are invalid.

Check the recipients’ addresses.
See section 1.4 in the communication manual.

265

SMTP protocol error.

May occur if a network failure (cable problems, duplicate

addresses, network device failure, and so on) occurs in

the middle of the e-mail transmission.

266

Ethernet cable is not connected.

Check the cable connection.
See section 1.3 in the communication manual.

267

Could not connect to SMTP server.

• Check to see that the SMTP server is connected to the

network.

• If the SMTP server name is specified using an IP

address, check to see that the IP address is correct.

See section 1.4 in the communication manual.

268

E-mail transmission request failed.

Contact your nearest YOKOGAWA dealer.

269

E-mail transfer error.

May occur if a network failure (cable problems, duplicate

addresses, network device failure, and so on) occurs in

the middle of the e-mail transmission.

270

Could not connect to POP3 server

Check the connection settings.
See section 1.4 in the communication manual.

271

Not able to login to the POP3 server.

Check the login name and the password.
See section 1.4 in the communication manual.

272

SMTP authentication failed.

Make sure that the user name and password that you are

using for authentication are recognized by the server.
See section 1.4 in the communication manual.

273

The server requested an unsupported authentication

method.

Change the server configuration.
See section 1.4 in the communication manual.

275

The current image cannot be output to the Web.

The setup display cannot be output to the Web browser.

This message is displayed on the Web browser.

276

Image data currently being created. Unable to perform key

operation.

Try again a little later. This message is displayed on the

Web browser.

277

Could not output screen to Web.

Failed to create the image. This message is displayed on

the Web browser.

10.1 A List of Messages