Setup items, Logic box number, Event action > event – Yokogawa Value Series FX1000 User Manual
Page 191: Event action > action
7-2
IM 04L21B01-01EN
Setup Items
• Logic box number
You can set up to 40.
• Event action > Event
The condition to execute the action.
Settings
Description
None
Not use.
Remote
Select the remote control input terminal number.
Relay
Select the alarm output relay number. During Edge operation, a change
from deactivated to activated is an event.
Switch
Select the internal switch number. During Edge operation, a change from off
to on is an event.
Timer
Select the timer number.
Matchtime
Select the match timer number.
Alarm
During Edge operation, a change from “no alarms are active” to “at least
one alarm is active” is an event.
USER key
-
• Event action > Action
The action to be executed when an event occurs.
Settings
Description
Memory
-
Start
-
Stop
-
Trigger
Can be specified when the FX is configured to record event data.
AlarmACK Cannot be specified when the event is set to
Relay, Switch, or Alarm.
Math
Can be specified on FXs with the /M1, /PM1, or /PWR1 option.
MathStrt
Start computation. Can be specified on FXs with the /M1, /PM1, or /PWR1 option.
MathStop
Stop computation. Can be specified on FXs with the /M1, /PM1, or /PWR1 option.
Math rst
Reset computation. Can be specified on FXs with the /M1, /PM1, or /PWR1 option.
SaveDisp
Can be specified when the FX is configured to record display data.
SaveEvt
Can be specified when the FX is configured to record event data.
Message
Set the message number to write the message and the destination. Set the
message destination to all groups (All) or a group number.
Snap
Snapshot
Rate1/2
Can be specified when the function for switching between the trend interval and
the secondary trend interval is enabled.
M.sample
Manual sampling
TimerRst
Cannot be specified when the event is set to
Timer.
Group
Specify the number of the group to be displayed.
Flag
Can be specified on FXs with the /M1, /PM1, or /PWR1 option.
Time adj
Can be specified only when the event is set to
Remote.
PnlLoad
Can be specified only when the event is set to
Remote.
7.1 Setting the Event Action Function
(Including the remote control function of the /R1 and /PM1 options and the USER key)