App index – Yokogawa Value Series FX1000 User Manual
Page 12
1-3
IM 04L21B01-01EN
Overview of Functions
3
2
1
4
5
6
7
8
9
10
11
12
13
14
App
Index
Difference computation
Square Root Computation
Calibration Correction (/CC1 Option)
Input
value
Input
value
Input
value
Input
value
DC voltage
Single-phase
two-wire system
Single-phase
three-wire system
Three-phase
three-wire system
Electric power
Electric energy
Measured value on the reference channel
–
The measured value of the channel is set to the
difference with respect to the measured value of the
reference channel
Low-cut
Converts the unit to obtain the measured value.
Takes the square root of the input value and converts
the unit to obtain the measured value.
Counts the pulses. Use the computation channels
(/M1, /PM1, and /PWR1 options).
You can apply a logarithmic voltage that has been
converted from a physical value to the FX, and then use
the FX’s Log scale (logarithmic scale) to display and
record the physical value.
Measure the measurement elements of electrical power.
Use the computation channels (/M1, /PM1, and /PWR1
options).
Pulse Input (/PM1 Option)
Logarithmic DC Voltage (/LG1 option)
AC Voltage and Current (/PWR1 option)
Linear Scaling
10 V
0 V
300 °c
–100 °c
a
b
x
a
b
B
B
X
A
A
X = (B – A)
+ A
x – a
b – a
Pulse that can be counted
FX input
Counted on the FX
For the setting procedure, see section 3.3.
For the setting procedure, see section 3.3.
For the setting procedure, see section 3.3.
For the setting procedure, see section 3.12.
For the setting procedure, see section 3.13.
VT ratio
CT ratio
Low-cut power
Input
value
AC (45 to 65 Hz)
Voltage and current
Measured
value
Input
value
Corrects the input value with the characteristics
specified by segments to obtain the measured value.
Number of break
points: Up to 16
Measured
value
Output
value
For the setting procedure, see section 3.9.
( )
Measured
value
Input
value
For square root computation, measured values below
the specified value are cut.
For 1-5 V input, values below 0 % are cut.
Result of square root
computation
Low-cut value
For the setting procedure, see section 3.3.
Measured
value
Measured
value
5 ms or more
100 Hz or less
Pulse
Contact
or
Open
collector
FX
The contact changes from open to close.
The signal level at the input terminal changes from high
to low.
For the setting procedure, see section 3.10.
Measured
value
Measured
value
1.1 Input Section