beautypg.com

Profibus dp - (decentralized peripherals), Software configuration – Watlow EZ-ZONE PM Integrated Controller User Manual

Page 147

background image

Watlow EZ-ZONE

®

PM Integrated Controller

144

Chapter 9 Features

Profibus DP - (Decentralized Peripherals)

This protocol is typically used to operate sensors and actuators via a centralized controller within industrial-

ized production topologies. Data rates up to 12 Mbit/s on twisted pair cables and/or fiber optics are possible.

This protocol is available in three functionally graded version; DP-V0, DP-V1 and DP-V2. It should be noted

that Watlow products utilizing this protocol support DP-V0 and DP-V1 only.
DP-V0 - provides the basic functionality of DP, including cyclic data exchange, station, module and channel

specific diagnostics and four different interrupt types for diagnostics and process interrupts.

Cyclic Data refers to input/output data that is pre-configured to pass from the Profibus-DP Class 1 Master

and the Slave at a known rate. Cyclic data is expected on both the sender and the receiver end of the mes-

sage.
Note:

To use DP-V0 (cyclic data transfer) first configure and then register the General Station Description (GSD)

file. Watlow provides a software tool allowing for total customization of the data to be read and or written

to. Acquire this software tool (Profibus GSD Editor) via the CD that shipped with the product or, as an al-

ternative, point your browser to:

http://www.watlow.com/products/controllers/software.cfm

and navigate to

the bottom of the page and click on "Software and Demos" to download the software.

Using the GSD Editor a user can configure up to a maximum of 135 different parameters that can be read

or written to from Zone 1 through 16. DP-V1 - contains enhancements geared towards process automation, in

particular acyclic data communication for parameter assignment, operation, visualization and interrupt con-

trol of intelligent field devices, in conjunction with cyclic user data communication.
Acyclic Data is a message that can be sent and or received at any time where they typically have a lower pri-

ority then cyclic messages. This type of messaging is typically used for the purpose of configuration or per-

forming some sort of a diagnostic function.

Software Configuration

Using EZ-ZONE

®

Configurator Software

To enable a user to configure the PM control using a personal computer (PC), Watlow has provided free soft-

ware for your use. If you have not yet obtained a copy of this software insert the CD (Controller Support

Tools) into your CD drive and install the software. Alternatively, if you are viewing this document electroni-

cally and have a connection to the internet simply click on the link below and download the software from

the Watlow web site free of charge.

http://www.watlow.com/products/software/zone_config.cfm

Once the software is installed double click on the EZ-ZONE Configurator icon placed on your desktop during

the installation process. If you cannot find the icon follow the steps below to run the software:
1. Move your mouse to the "Start" button
2. Place the mouse over "All Programs"
3. Navigate to the "Watlow" folder and then the sub-folder "EZ-ZONE Configurator"
4. Click on EZ-ZONE Configurator to run.
The first screen that will appear is shown below.