Watlow EZ-ZONE PM Integrated Controller - Manual (Page 116)

Watlow EZ-ZONE ® PM Integrated Controller • 113 • Chapter 8 Factory Page
To go to the Factory Page from the Home Page,
press and hold both the Advance ‰ and Infinity ˆ
keys for six seconds.
• Press the Up ¿ or Down ¯ key to view available
menus. On the following pages top level menus
are identified with a yellow background color.
• Press the Advance Key ‰ to enter the menu of
choice.
• If a submenu exists (more than one instance),
press the Up ¿ or Down ¯ key to select and then
press the Advance Key ‰ to enter.
• Press the Up ¿ or Down ¯ key to move through
available menu prompts.
• Press the Infinity Key ˆ to move backwards
through the levels: parameter to submenu; sub-
menu to menu; menu to Home Page.
• Press and hold the Infinity Key ˆ for two seconds
to return to the Home Page.
Chapter 8: Factory Page
Navigating the Factory Page
Note:
Some of these menus and parameters may not appear, depending on the controller's options. See model
number information in the Appendix for more information. If there is only one instance of a menu, no sub-
menus will appear.
8
[CUSt]
[FCty]
Custom Setup Menu
[```1]
[CUSt]
Custom Setup (1 to 20)
[`par] Parameter
[`iid] Instance ID
[`LoC]
[FCty]
Security Setting Menu
[`LoC] Security Setting
[LoC;o] Operations Page
[LoC;P] Profiling Page
[pas;e] Password Enabled
[RloC]
Read Lock
[SLoC] Write Security
[loC;l] Locked Access Level
[roll] Rolling Password
[pas;u] User Password
[pas;a] Administrator Password
[ULoC]
[FCty]
Security Setting Menu
[Code] Public Key
[pass] Password
[diAg]
[FCty]
Diagnostics Menu
[diAg] Diagnostics
[``Pn] Part Number
[`rEu] Software Revision
[S;bld] Software Build Number
[``Sn] Serial Number
[dAtE] Date of Manufacture
[ip;aC] IP Actual Address Mode
[ip;a1] IP Actual Address Part 1
[ip;a2] IP Actual Address Part 2
[ip;a3] IP Actual Address Part 3
[ip;a4] IP Actual Address Part 4
[ip;a5] IP Actual Address Part 5
[ip;a6] IP Actual Address Part 6
[`CAL]
[FCty]
Calibration Menu
[```1]
[`Cal]
Calibration (1 to 2)
[`Mu] Electrical Measurement
[ELi;o] Electrical Input Offset
[ELi;S] Electrical Input Slope
[ELo;o] Electrical Output Offset
[ELo;s] Electrical Output Slope
[``Pn] Part Number
[Code] Code
Note:
Some of the listed parameters may not be visible. Parameter visibility is dependent upon controller part
number.