IAI America XSEL-S - Manual (Page 35)

5. V
ision System I/F Function Setting
29
5.5 Unit Conversion (pixel Ÿ mm)
This manual is provided on the premise that the unit of the coordinate data that is received in Vision
System I/F Function is [mm]. Provide a setting on the camera controller side to have the unit of the
output coordinate data in [mm]. [Refer to the Instruction Manual for the Vision System to be
connected for the details.]
(Note) The setting is not necessary when using the simple (dedicated) calibration with EZ-110XL
since the setting is conducted in Section 5.8.
5.6 Coordinate Setting
Set the coordinate axes of the vision system.
Refer to the following to set the coordinates on the camera controller side in accordance with the
parameter settings in Vision System I/F Function. [Refer to the Instruction Manual for the Vision
System to be connected for the details.]
(Note) The setting is not necessary when using the simple (dedicated) calibration with EZ-110XL
since the setting is conducted in Section 5.8.
[For Cognex (except for EZ-110XL) or OMRON : I/O Parameter No.352=0 or 1]
Conduct the setting to place the origin on the bottom left of the captured data.
㪯
㪰
[For Keyence : I/O Parameter No.352=2]
Conduct the setting to place the origin on the upper left of the captured data.
㪯
㪰