IAI America XSEL-S - Manual (Page 27)

5. V
ision System I/F Function Setting
21
5. Vision System I/F Function Setting
Refer to the materials such as the Instruction Manual for the connected camera controller for the
details of how to set up on the camera controller side.
This manual explains how to set up the system to utilize the vision system I/F function.
The setting is to be conducted using XSEL Controller, PC software and the setting tool of each
vision system.
5.1 Setting Procedure
Continues to the next page
RS232C Channel Setting (setting on XSEL)
Follow Section 5.3.2.
Which of the following is used for the communication between the vision system (camera)
and XSEL Controller?
1) Ethernet 2) RS232C
(Cognex or Keyence) (OMRON or Keyence)
Start up the PC software and connect with XSEL Controller.
Start up the vision system setting tool and connect with the vision system.
Supplier Setting of Connected Camera (setting on XSEL)
Set the supplier name of the connected camera following Section 5.4.
Vision System Check and Communication Setting (setting on vision system)
Perform the necessary settings such as image setting, tool setting, inspection, input,
output and communication with using the vision system setting tool.
Set the unit of the output of the coordinate data from the vision system to mm except for
when using the dedicated calibration with EZ-110XL. (Refer to Section 5.5)
Coordinate Setting (setting on vision system)
Set the coordinate origin of the vision system following Section 5.6.
This setting is not necessary when using the dedicated calibration with EZ-110XL.
Detailed Function Settings (setting on XSEL)
Set the image-capture command input port number and other necessary numbers
following Section 5.7.
Ethernet Channel Setting (setting on XSEL)
Follow Section 5.3.1.
Setting Start