IAI America XSEL-KET - Manual (Page 421)

Appendi
x
INTELLI
GENT A
CTUAT
OR
402
(In the panel window, the three digits after “E” indicate an error number.)C
Error No. Error name Description, action, etc.
E79 Abnormal response error when sending EEPROM-data setting
slave command
An abnormal response was received when an EEPROM-data setting
slave command was sent.
E7A Maximum receive size over error when sending EEPROM-
data setting slave command The receive size exceeded the limit value when an EEPROM-data
setting slave command was sent.
E7B Motor-drive power ON timeout error Abnormal current flow from the motor-drive power source
E7C Register read/write test error Error reading/writing the register
E7D Linear-movement axis parameter error Check axis-specific parameter Nos. 38, 68, 1, etc.
E7E Parameter error The parameter is invalid.
E7F Stroke parameter error Check axis-specific parameter Nos. 7, 8, 1, etc.
E80 Unsupported card error An unsupported card is installed in an I/O slot.
E81 Priority auto-assignment card non-detection error Priority auto-assignment card cannot be detected.
E82 Card mismatch error The combination or positioning of I/O slot cards has a problem.
E83 I/O slot card error The I/O slot card is invalid.
E84 Resolution parameter error Check axis-specific parameter Nos. 47, 50, 51, 44, 42, 43, 1, 37, etc.
E85 Driver ready OFF factor indeterminable error Driver ready OFF factor cannot be determined.
E86 Fieldbus error (FBVCCER) A fieldbus error (FBVCCER) was detected.
E87 Fieldbus error (FBPOWER) A fieldbus error (FBPOWER) was detected.
E88 Power error (Other) A power error (Other) was detected. This error also generates when the
power OFF
 ON interval is short. After the power has been turned off,
be sure to wait for at least 5 seconds before turning it back on.
Abnormal regenerative resistance temperature is also suspected.
E89 SCIF open error in non-AUTO mode (Servo in use) In a mode other than AUTO, opening of the serial 1 channel (also used
by the PC software/TP port) from a SEL program is prohibited while the
servo is in use (to ensure safety).
E8A SEL program flash-ROM status error Data is not written to the flash ROM correctly or written in an old,
incompatible application version.
E8B Symbol definition table flash-ROM status error Data is not written to the flash ROM correctly or written in an old,
incompatible application version.
E8C Point data flash-ROM status error Data is not written to the flash ROM correctly or written in an old,
incompatible application version.
E8D Parameter flash-ROM status error Data is not written to the flash ROM correctly or written in an old,
incompatible application version.
FF0 ~
F00
Shutdown error (hi_sysdwn () definition) A shutdown error (hi_sysdwn () definition) was detected.
F03 ~
F58
Shutdown error (OS call error) A shutdown error (OS call error) was detected.