Pcon-ca/cfa, Power con, Caution – IAI America PCON-CA User Manual
Page 282: Push force and current-limiting value, Chapter 9 appendix
Chapter 9
Appendix
POWER CON
PCON-CA/CFA
274
Push Force and Current-limiting Value
x
The relationship of push force and current-limiting value is based on the rated push speed
(factory setting) and provides only a guideline.
x
Make sure the actual push force is equal to or greater than the minimum push force. If not,
the push force will not stabilize.
x
Do not change the setting of push speed (parameter No.34). If you must change the push
speed, consult IAI.
x
If, among the operating conditions, the positioning speed is set to a value equal to or
smaller than the push speed, the push speed will become the set speed and the specified
push force will not generate.
RCP2 Series
Rod Type
RA2C Type
Current-limiting value (ratio, %)
P
us
h
fo
rc
e
(N
)
High-speed type
Medium-speed ty
pe
Low-speed type
Current-limiting value (ratio, %)
P
us
h
fo
rc
e
(N
)
Current-limiting value (ratio, %)
P
us
h
fo
rc
e
(N
)
Current-limiting value (ratio, %)
P
us
h
fo
rc
e
(N
)
Current-limiting value (ratio, %)
P
us
h
fo
rc
e
(N
)
Current-limiting value (ratio, %)
P
us
h
fo
rc
e
(N
)
Current-limiting value (ratio, %)
P
us
h
fo
rc
e
(N
)
Current-limiting value (ratio, %)
P
us
h
fo
rc
e
(N
)
Current-limiting value (ratio, %)
P
us
h
fo
rc
e
(N
)
Caution