IAI America PCON-CA - Manual (Page 19)

POWER CON
PCON-CA/CFA
11
12. PLC Timer Setting
Do not have the PLC timer setting to be done with the minimum setting.
Setting to “1” for 100msec timer turns ON at the timing from 0 to 100msec while 10msec timer
from 0 to 10msec for some PLC.
Therefore, the same process as when the timer is not set is held and may cause a failure such
as the actuator cannot get positioned to the indicated position number in Positioner Mode.
Set “2” as the minimum value for the setting of 10msec timer and when setting to 100msec, use
10msec timer and set to “10”.
International Standards Compliances
PCON-CA comply with the following international standards:
Refer to Overseas Standard Compliance Manual(ME0287) for more detailed information.
RoHS Directive CE Marking UL
{ To be scheduled To be scheduled