Acer AB460 F1 User Manual
Page 578
5 Acer Smart Blade Manager
558
ID: Shows the status of the ID LED. Check Enable to enable the ID. Once
enabled, the ID LED on the blade panel will flash.
System Fault: Indicates the system fault status.
BMC: Shows BMC status. If a BMC module is installed, the BMC IP
address will appear here. Use Update to update the BMC IP. Click
to
reload the BMC IP. If BMC is not installed
not installed
appears and the
buttons are disabled.
Watt: The estimated power consumption (wattage) of the blade. It is a
static value supplied by BIOS.
Power Control
Power On: Click to power on the blade.
Reset: Click to reset the blade.
Graceful Shutdown: Click to perform a graceful shutdown on the
blade.
Power Down: Click to power down the blade.
Sensors
This section displays the motherboard identifier for easy reference. The
sensor table shows the CPU(s), system temperature and voltages of the
selected blade system.
The table headers indicate the status, sensor name, reading and the
low and high limits. If the status of a sensor is normal, the reading will
be in blue and the sensor will have an OK symbol. If a sensor status is
out of range, the reading will be red and the sensor will have a fail
symbol. If the sensor is not present the reading will be N/A.