Acer AB460 F1 - Manual (Page 115)

95
Figure 3-56. Locking the Blade into Position
Processor Installation
Up to four processors may be installed to the mainboard of each blade
unit. See “AB460 F1” on page 147 or “AB2x280 F1” on page 203 for
general information on the features of the blade units.
Warning! These procedures should only be performed by a
trained service technician. Allow the processor heatsink to
cool before removing it.
Removing a Processor
1. Power down and remove the blade unit from the enclosure (see
Section : Installing Blade Modules on page 92 for details).
2. Remove the cover of the blade unit (see "Removing/Replacing the
Blade Cover" on page 93).