Acer AB460 F1 - Manual (Page 36)

2 Chassis Enclosure 16
5. (Optional step) Add the front left and right handles to the
enclosure using five screws to secure each handle. Install a
thumbscrew through the bottom hole of each handle (see
Figure 2-7).
Note: These handles are optional and need only be installed when
mounting the system into a short rack. When mounting into a
deep rack, they are unnecessary and regular screws should be used
instead of thumbscrews.
Be aware that these handles are not to be used for lifting the system, they are
only to be used to slide the system within the rack.
6. With one person on either side (see the descriptive label on the
side of the enclosure), lift the enclosure and slide it into the
installed rails.
Warning! Be sure that the enclosure is empty of all blades, power sup-
plies, switches and management modules BEFORE lifting. These should
be installed AFTER the enclosure is mounted in the rack. Injury and dam-
age may occur if components are not removed from the rack prior to in-
stallation.
7. After pushing the enclosure all the way into the rack, use two
roundhead screws on each side of the server to lock it into place.
Figure 2-7. Attaching the Optional Handles
8. The enclosure is now securely installed in the rack (see Figure 2-8).