Acer AB460 F1 - Manual (Page 382)

4 Networking Switch Modules 362
Port Settings
Clicking the P ORT S ETTINGS tab brings up the P ORT S TATUS C ONFIGURATION
page, which allows you to set the configuration per port related to
RSTP. The parameters for this page are shown in the following table.
Default Path Cost
Version This parameter allows you to configure the path cost
either as a
16-bit value or a 32-bit value. This is
provided mainly for backward compatibility with STAP.
Parameter Description
Port This parameter specifies the port identifier.
Status This parameter enables or disables the RSTP protocol
status on a particular port.
Priority This parameter specifies the port priority used in role
selection.
Path Cost This parameter specifies the path cost associated with
this port.
Parameter Description