Acer AB460 F1 - Manual (Page 34)

2 Chassis Enclosure 14
power supply connections other than the direct connections to the
branch circuit (such as the use of power strips and so on).
Note: It is recommended that you seek the advice and assistance
of a licensed electrician that can advise you on best practices for
ensuring that the electrical supply and the rack are joined to a
Common Bonding Network .
Professional documents on grounding techniques include:
•
ANSI/TIA-942 – Telecommunications Infrastructure Standard for
Data Centers
• J-STD-607-A-2002 – Commercial Building Grounding (Earthing) and
Bonding Requirements for Telecommunications
• IEEE Std 1100™-2005 (IEEE Emerald Book) – IEEE Recommended
Practice for Powering and Grounding Electronic Equipment
Installing the System Into a Rack
This section provides information on installing the AB7000 into a rack.
There are a variety of rack units on the market, meaning the procedure
may differ slightly. Refer to the Enclosure Template that was included
with the system for help.
Rack Mounting Hardware
The following is a list of rack mounting hardware you will need for
rack setup and installation:
•
Two rail assemblies (one for each side of the enclosure)
• Two handles
• Four roundhead screws for fastening the enclosure ears to the rack
• Eight flathead screws and washers for mounting the rails to the
rack
Installation
Use the procedure below for installing an enclosure in a rack.