Acer AB460 F1 - Manual (Page 420)

4 Networking Switch Modules 400
Pool Settings
Clicking the P
OOL
S
ETTINS
link brings up the DHCP P
OOL
S
ETTINGS
page,
which allows you to configure the IP address pool that can be used by
the DHCP server to allocate IP addresses. The parameters for this page
are shown in the following table.
Parameter Description
Pool ID This parameter specifies the pool ID to index among
the different subnet pools configured.
Network This parameter specifies the subnet of the IP address in
the pool.
Subnet Mask This parameter specifies the subnet mask of the IP
address in the pool.
Start IP This parameter specifies the first IP address in the
address pool that is used for dynamic allocation by the
DHCP server.
End IP This parameter specifies the last IP address in the
address pool that is used for dynamic allocation by the
DHCP server.