Acer AB460 F1 - Manual (Page 489)

469
Clicking the S
TATIC
RP tab brings up the S
TATIC
RP C
ONFIGURATION
page,
which configure static PIM RPs (Rendezvous Points). The parameters for
this page are shown in the following table.
DVMRP
The DVMRP page allows you to configure the DVMRP protocol using
the following pages:
•
“DVMRP Basic Settings” on page 470
• “Interfaces” on page 471
Parameter Description
Component ID This parameter specifies a number uniquely identifying
the component.
Address Type This parameter chooses the IPv4 or IPv6 address type.
Static Group
Address This parameter represents the multicast group, for
which the switch advertises itself as the candidate RP.
Static Group Mask This parameter specifies the subnet mask, which when
combined with the group address gives the group
prefix.
Static RP Address This parameter represents the IP address of the
candidate RP.