Acer AB460 F1 - Manual (Page 344)

4 Networking Switch Modules 324
QoS Classmap Settings
Clicking the C
LASSMAP
tab brings up the Q
O
S C
LASSMAP
S
ETTINGS
page,
which is used to classify the stream of traffic. The parameters for this
page are shown in the following table.
Parameter Description
System Control With this parameter S YSTEM C ONTROL can Start or
Shutdown QoS.
Status This parameter allows enabling/disabling of the QoS
status.
Figure 4-207. QoS Classmap Settings
Parameter Description
Classmap ID This parameter specifies a unique ID for the Classmap.
It must be in the range from
1 to 65535 .
Filter ID This parameter specifies the unique filter ID associated
with this Classmap.