Acer AB460 F1 - Manual (Page 286)

4 Networking Switch Modules 266
Network Connection
Use the procedure below to connect and login to the Acer Smart Blade
Console.
Logging In to the Acer Smart Blade Console:
1. Connect a PC to a network that is accessible to the switch.
For example, connect a PC to any of the front panel ports of the
switch and make sure the PC has an IP address on the same subnet
as the switch management IP.
2. Type the IP address of the switch that you want to connect to in
the address bar of your browser, and hit NTER >. Once the
connection is made, the L
OGIN
screen displays
Note: The default username is root and the default password is
superuser. The Default IP address is
192.168.100.102 .
Address Defaults
The following are the default addresses that are initially set.
Afterwards, you can change these values within the program.
Note: If two switches are installed in a AB7000 system, you will
have to change the IP address of one from the default so that
both switches have unique addresses.
Acer Smart Blade Manager
Use the procedure below to login to the Acer Smart Blade Manager.
Address Default Setting
Default IP Address 192.168.100.102
Default Acer Address 192.168.100.1
Default Subnet Mask 255.255.255.0