beautypg.com

6 output compare units, See “output compare – Rainbow Electronics ATmega64C1 User Manual

Page 115

background image

115

7647A–AVR–02/08

ATmega32/64/M1/C1

13.5.4

Using the Input Capture Unit as TCNT1 Retrigger Input

TCNT1 counts from BOTTOM to TOP. The TOP value can be a fixed value, ICR1, or OCR1A.
When enabled the Retrigger Input forces to reach the TOP value. It means that ICF1 output is
ored with the TOP signal.

13.6

Output Compare Units

The 16-bit comparator continuously compares TCNTn with the Output Compare Register
(OCRnx). If TCNT equals OCRnx the comparator signals a match. A match will set the Output
Compare Flag
(OCFnx) at the next timer clock cycle. If enabled (OCIEnx = 1), the Output Com-
pare Flag generates an Output Compare interrupt. The OCFnx Flag is automatically cleared
when the interrupt is executed. Alternatively the OCFnx Flag can be cleared by software by writ-
ing a logical one to its I/O bit location. The Waveform Generator uses the match signal to
generate an output according to operating mode set by the Waveform Generation mode
(WGMn3:0) bits and Compare Output mode (COMnx1:0) bits. The TOP and BOTTOM signals
are used by the Waveform Generator for handling the special cases of the extreme values in
some modes of operation (

See “16-bit Timer/Counter1 with PWM” on page 106.

)

A special feature of Output Compare unit A allows it to define the Timer/Counter TOP value (i.e.,
counter resolution). In addition to the counter resolution, the TOP value defines the period time
for waveforms generated by the Waveform Generator.

Figure 13-4

shows a block diagram of the Output Compare unit. The small “n” in the register and

bit names indicates the device number (n = n

for Timer/Counter n), and the “x” indicates Output

Compare unit (x). The elements of the block diagram that are not directly a part of the Output
Compare unit are gray shaded.

Figure 13-4. Output Compare Unit, Block Diagram

The OCRnx Register is double buffered when using any of the twelve Pulse Width Modulation
(PWM) modes. For the Normal and Clear Timer on Compare (CTC) modes of operation, the

OCFnx (Int.Req.)

=

(16-bit Comparator )

OCRnx Buffer (16-bit Register)

OCRnxH Buf. (8-bit)

OCnx

TEMP (8-bit)

DATA BUS

(8-bit)

OCRnxL Buf. (8-bit)

TCNTn (16-bit Counter)

TCNTnH (8-bit)

TCNTnL (8-bit)

COMnx1:0

WGMn3:0

OCRnx (16-bit Register)

OCRnxH (8-bit)

OCRnxL (8-bit)

Waveform Generator

TOP

BOTTOM