Rainbow Electronics W90N745CDG User Manual
Page 59
W90N745CD/W90N745CDG
- 54 -
Power Management Control Register (PMCON)
REGISTER ADDRESS
R/W
DESCRIPTION
RESET
VALUE
PMCON
0xFFF0_0028 R/W
Power Management Control Register
0x0000_0000
31
30
29
28
27
26
25
24
RESERVED
23
22
21
20
19
18
17
16
RESERVED
15
14
13
12
11
10
9
8
RESERVED
7
6
5
4
3
2
1
0
RESERVED MIDLE
PD
IDLE
BITS
DESCRIPTION
[31:3] RESERVED
[2] MIDLE
Memory controller IDLE enable
Setting both MIDLE and IDLE bits HIGH will let memory controller
enter IDLE mode, the clock source of memory controller will be halted
while ARM CORE enter IDLE mode.
1=memory controller will be forced into IDLE mode, (clock of memory
controller will be halted), when IDLE bit is set.
0 = memory controller still active when IDLE bit is set.
NOTE: Software must let SDRAM enter self-refresh mode before
enable this function because SDRAM MCLK will be stopped.
[1] PD
Power down enable
Setting this bit HIGH will let W90N745 enter power saving mode. The
clock source 15M crystal oscillator and PLLs are stopped to generate
clock. User can use nIRQ[3:0], keypad and external RESET to wakeup
W90N745.
1 = Enable power down
0 = Disable
[0] IDLE
IDLE mode enable
Setting this bit HIGH will let ARM Core enter power saving mode. The
peripherals can still keep working if the clock enable bit in CLKSEL is
set. Any nIRQ or nFIQ to ARM Core will let ARM CORE to exit IDLE
state.
1 = IDLE mode
0 = Disable