ZyXEL Communications 5 Series - Manual (Page 799)

ZyWALL 5/35/70 Series User’s Guide
Appendix K Command Interpreter 799
A
P P E N D I X
K
Command Interpreter
The following describes how to use the command interpreter. Enter 24 in the main menu to
bring up the system maintenance menu. Enter 8 to go to Menu 24.8 - Command Interpreter
Mode. See the included disk or zyxel.com for more detailed information on these commands.
Note: Use of undocumented commands or misconfiguration can damage the unit and
possibly render it unusable.
Command Syntax
• The command keywords are in courier new font.
• Enter the command keywords exactly as shown, do not abbreviate.
• The required fields in a command are enclosed in angle brackets <>.
• The optional fields in a command are enclosed in square brackets [].
• The |symbol means or.
For example,
sys filter netbios config
means that you must specify the type of netbios filter and whether to turn it on or off.
Command Usage
A list of valid commands can be found by typing help or ? at the command prompt. Always
type the full command. Type exit to return to the SMT main menu when finished.
Command Examples
This section provides some examples of commands you can use on the ZyWALL. See the
other appendices for more examples.
Configuring What You Want the ZyWALL to Log
1 Use the sys logs load command to load the log setting buffer that allows you to
configure which logs the ZyWALL is to record.
2 Use sys logs category to view a list of the log categories.