ZyXEL Communications 5 Series - Manual (Page 520)

ZyWALL 5/35/70 Series User’s Guide
520 Chapter 30 Logs Screens
Rule [%d] Phase 2
authentication algorithm
mismatch
The listed rule’s IKE phase 2 authentication algorithm did not
match between the router and the peer.
Rule [%d] Phase 2
encapsulation mismatch
The listed rule’s IKE phase 2 encapsulation did not match
between the router and the peer.
Rule [%d]> Phase 2 pfs
mismatch
The listed rule’s IKE phase 2 perfect forward secret (PFS)
setting did not match between the router and the peer.
Rule [%d] Phase 1 ID mismatch The listed rule’s IKE phase 1 ID did not match between the
router and the peer.
Rule [%d] Phase 1 hash
mismatch
The listed rule’s IKE phase 1 hash did not match between the
router and the peer.
Rule [%d] Phase 1 preshared
key mismatch
The listed rule’s IKE phase 1 pre-shared key did not match
between the router and the peer.
Rule [%d] Tunnel built
successfully
The listed rule’s IPSec tunnel has been built successfully.
Rule [%d] Peer's public key
not found
The listed rule’s IKE phase 1 peer’s public key was not found.
Rule [%d] Verify peer's
signature failed
The listed rule’s IKE phase 1verification of the peer’s
signature failed.
Rule [%d] Sending IKE request IKE sent an IKE request for the listed rule.
Rule [%d] Receiving IKE
request
IKE received an IKE request for the listed rule.
Swap rule to rule [%d] The router changed to using the listed rule.
Rule [%d] Phase 1 key length
mismatch
The listed rule’s IKE phase 1 key length (with the AES
encryption algorithm) did not match between the router and
the peer.
Rule [%d] phase 1 mismatch The listed rule’s IKE phase 1 did not match between the router
and the peer.
Rule [%d] phase 2 mismatch The listed rule’s IKE phase 2 did not match between the router
and the peer.
Rule [%d] Phase 2 key length
mismatch
The listed rule’s IKE phase 2 key lengths (with the AES
encryption algorithm) did not match between the router and
the peer.
Remote Gateway Addr in rule
[%s] is changed to %s"
The IP address for the domain name of the peer gateway in
the listed rule changed to the listed IP address.
New My ZyWALL Addr in rule
[%s] is changed to %s
The IP address for the domain name of the ZyWALL in the
listed rule changed to the listed IP address.
Remote Gateway Addr has
changed, tunnel [%s] will be
deleted
The listed tunnel will be deleted because the remote
gateway’s IP address changed.
My ZyWALL Addr has changed,
tunnel [%s] will be deleted
The listed tunnel will be deleted because the ZyWALL’s IP
address changed.
Table 179 IKE Logs (continued)
LOG MESSAGE DESCRIPTION