3 problems with the dmz interface, 4 problems with the wan interface, Table 261 troubleshooting the dmz interface – ZyXEL Communications 5 Series User Manual
Page 704: Table 262 troubleshooting the wan interface
ZyWALL 5/35/70 Series User’s Guide
704
Chapter 52 Troubleshooting
52.3 Problems with the DMZ Interface
52.4 Problems with the WAN Interface
Table 261 Troubleshooting the DMZ Interface
PROBLEM
CORRECTIVE ACTION
Cannot access
servers on the DMZ
from the LAN.
Check your Ethernet cable type and connections. Refer to the Quick Start Guide
for DMZ connection instructions.
Make sure the Ethernet adapters on the LAN computer and the DMZ server are
installed and functioning properly.
Verify that the IP address of the DMZ port and the LAN port are on separate
subnets.
Make sure that NAT is configured for your DMZ servers.
Cannot ping any
computer on the
DMZ.
Check the 10M/100M DMZ LEDs on the front panel. One of these LEDs should
be on. If they are both off, check the cables between your ZyWALL and hub or
the station.
Verify that the IP address and the subnet mask of the ZyWALL and the servers
are on the same subnet.
Table 262 Troubleshooting the WAN Interface
PROBLEM
CORRECTIVE ACTION
Cannot get WAN IP
address from the
ISP.
The ISP provides the WAN IP address after authentication. Authentication may
be through the user name and password, the MAC address or the host name.
Use the following corrective actions to make sure the ISP can authenticate your
connection.
You need a user name and password if you're using PPPoE or PPTP
encapsulation. Make sure that you have entered the correct Service Type, User
Name and Password (the user name and password are case sensitive). Refer
to
or
If your ISP requires MAC address authentication, you should clone the MAC
address from your computer on the LAN as the ZyWALL's WAN MAC address.
Refer to
. It is recommended
that you clone your computer's MAC address, even if your ISP presently does
not require MAC address authentication.
If your ISP requires host name authentication, configure your computer's name
as the ZyWALL's system name. Refer to
.